No results were found for the filter!
Guide plate for 2x holes for countersunk screw,with oil grooves,2 pieces are required for a revision
From €49.00 *
Piston ring for airhammer AN ring for airhammer AN-09, rear pistonset of two pieces, diameter ø mm
From €61.00 *
Air filter for AN-L powerhammer suitable for all AN-L air hammer models,45° angled, with band clamp,prevents the ingress of dirt and is rewashable.
€28.00 *
flat die top part for spring hammer type Meitinger Rationell or Record60x60 mm, height approx. 150 mm, high quality tool steel, properly hardened
€480.00 *
flat die bottom part for spring hammer type Meitinger Rationell or Recordmade from high quality tool steel, properly hardened
€390.00 *
fullering die top part for spring hammer type Meitinger Rationell or Record,height approx. 150 mm, 60 x 60 mm,high quality tool steel, properly hardened
€480.00 *
fullering die bottom part for spring hammer type Meitinger Rationell or Recordmade from high quality tool steel, properly hardened
€390.00 *
combination die top part for spring hammer type Meitinger Rationell or Recordsteel C65, hardened,drawing die and flat die.
€540.00 *
combination die (drawing / flat) bottom part for spring hammer type Meitinger Rationell or Record,made from high quality tool steel, properly hardened
€410.00 *
combination die top part for spring hammer type Meitinger Rationell or Recordsteel C65, hardened,flat die and fullering die (R=75 mm)
€540.00 *
combination die (flat/fullering) bottom part for spring hammer type Meitinger Rationell or Record,made from high quality tool steel, properly hardened,flat die and fullering die (R=75...
€410.00 *
Drawing die top part for spring hammer type Meitinger Rationell or Record,height approx. 150 mm, width 60 mm,high quality tool steel, properly hardened
€480.00 *
large Drawing die top part for spring hammer type Meitinger Rationell or Record,height approx. 150 mm, width 120 mm,high quality tool steel, properly hardened
€480.00 *
Spring support for setting up air hammer or spring hammer,60 Shore,outer diameter 47 mm,inner diameter ~ 17 mm
€14.90 *
Hydraulic forging press AN-Y04-25t for hot-freeform-forging,25 MPa (~ 25 t) press capacity,lift height 300 mm,lifting speed without load:down: 40 mm/sup: 60 mm/s7 mm/s...
€10,980.00 *
Hydraulic forging press AN-Y04-50t for hot-freeform-forging,50 MPa (~ 50 t) press capacity,lift height 300 mm,lifting speed without load:down: 50 mm/s, up: 55 mm/s8 mm/s...
€18,450.00 *
Viewed